Permabond 105 (was C6)
Instant Adhesive - Difficult Materials
|
| Permabond C6 is a very high
purity cyanoacrylate adhesive which can be used to bond a wide range of
materials that may be difficult to bond with general purpose ‘super
glues’. It is particularly suitable for bonding Natural rubber, Butyl
rubber and EPDM. It can easily be applied direct from the bottle or via
automated dispensing equipment where speed and/or precision are required. |
|
Colour |
Colourless |
|
Viscosity (mPa.s) |
40 |
|
Specific Gravity |
1.05 |
|
Handling Time |
1 – 7 seconds |
|
Full Strength |
24 hours |
|
Tensile Strength (MPa) |
20 |
|
Gap Fill (mm) |
0.1 |
|
Temp Range |
-30 / 85 °C |
|
Bottle Sizes Stocked in NZ |
20 g |
|
 |
|
Contact us for copies of Technical and Safety Data Sheets |
| CAUTION: Cyanoacrylate
adhesives will bond skin and eyes in seconds. Contact with
skin and eyes needs to be avoided. Use in a well ventilated
area. |
|
Directions for use:
The surfaces to be bonded should be dry, clean and free from oil
grease. The use of Permabond Cleaner A or other organic
solvents such as acetone or Methyl Ethyl Ketone (MEK) is
recommended. Persistent contamination should be removed by
abrasion prior to degreasing.
Apply the adhesive sparingly to one surface and bring the components
together quickly and in correct alignment. Squeeze the
parts together with sufficient pressure to ensure the adhesive
spreads to cover the surfaces. Do not disturb the joint until
handling strength is reached.
Product should be stored in a 'fridge but should be allowed to reach
room temperature before opening to prevent condensation causing
premature hardening.
Cure speed can be adjusted by the use of Permabond C
Surface Conditioner (CSA). |
|
|
View
all Permabond products |
